Getting My h4831sc load data To Work

Getting My h4831sc load data To Work

Blog Article

Due to the fact there would not seem like any "official" Load Data around for this Load, can many of you give a place to begin with this mix and points to think about when Doing the job this Load up?

Certainly, the Hodgdon tech wouldn't endorse my mixing of different ton figures, but I think I realize why. It is a litigation-driven world, plus some idiot would undoubtedly deduce that he could combine H380 and H110 and come up with his own tailor made combination of powder. What a planet.

The obvious cause is a rough/ruff bore. No number of copper fouling lessening brokers from the powder will almost certainly suitable this.

Sweet!! I am going to decide on some up and provides it a attempt. Thank you guys, I appreciate it! I'll let you know what I find out. I do have a few half pound of 4350 I can try that first and find out what comes about.

The only real variation as I are aware of it is that the SC was created to perform by means of powder measures much better (which it does). The lengthier grains do not feed properly in any way in some measures. Thats my 02 :grin:

I've made use of H4831 and H4831SC in my 260 Rem without having distinction. The only thing may be the limited Reduce offers you a bit more Room. Very good luck!gun)

I don't love to work up a load applying a single number of powder after which have to operate up again due to the fact I operate out and h4831sc also have to get started on using a new whole lot number.

Anyhow, I planned to give some 7828SC a try and lower a number of the compression. What a mistake, I could not get this powder to shoot h4831sc load data properly or make the velocities I get with standard 7828.

With all the quick Slash Edition powder will come around The bottom from the decreased shoulder so I nonetheless have numerous space.

You might have to make a handful of much more posts to get cleared to carry out PM's. When you finally get to that position I would publish during the labeled reloading segment to see if everyone is near you for just a trade. Click on to expand...

If there is not any load data it can be mainly because this powder is just not ideal for this cartridge. Generally one will likely not come across one particular powder to fit all cartridges, as well as relatives of cartridges with the particular powder (4831SC) that you are inquiring about will not work. Click on to broaden...

This is often an extreme extruded propellant and offers heightened insensitivity to hot and cold temperatures.

You could both: one) Go on and have the things mentioned below immediately removed from your searching cart:

I found that my 7mag one hundred sixty partitions ended up sub MOA with 4831sc with small to min charges. I’m talking 2700 (perhaps 2800) fps, h4831sc load data it had been a lower 60s grain demand inside of a Norma circumstance. Not what I was searching for, but correct Nevertheless.